• Welcome to the Yamaha FZ6R Forums. Member registration disables ads and allows you to post and share. Register Here.

T-Rex Racing No-Cut Sliders Group Buy (Ends Oct 31st)

Status
Not open for further replies.
Mine touched the engine using the single washer supplied in the kit. I had to add 3 more to it so it wouldn't rest on the engine.
 
It's possible that if enough vibration exists, you would erode the outer metal of the engine. A situation best avoided if possible. Plus, if the sliders touch the engine and you go down, there is no cushion of space between them, and there will likely be additional damage. Whereas, if there is room for movement, it's possible that less damage will be done during a fall.
 
When you installed the left side does your slider touch the engine or is it away from the engine? Mine sits against the engine. Wasn't sure if that's the way they are supposed to be.

once i put the two washers on it, i had mine at about 4 o'clock direction. it is extremely close/ maybe touching a bit, but i dont think its going to hurt it at all. btw, you could even get a little closer to the 3 o'clock position and it will still clear the fairing.
 
I seen this original post for this offer was last year, do you think he would still give the same offer for all of us newbies to the forum?

Thanks
 
Status
Not open for further replies.
Back
Top