Two Brothers Juice Box + Header?

[MikeN02]

That looks tons better than before! :thumbup: However, I do agree that the midpipe is too long. Take it to an exhaust place and see what they can do to shorten it and possibly make it a midship exhaust. That is, unless you like it out there, then leave it. It is YOUR bike!

BTW, it doesn't sound near as bad as you make it out. If you like, roll with it.

I went to a custom muffler shop and he said he'd have to build me a new mid pipe that would look out of place. It's hard to bend stainless if you cut it down because you're gonna have to flair out a the end piece.

Then I went to a bikes only shop where he does custom paint, exhausts and everything else. Guy wanted to sell me one of his GP pipes instead, and said my pipe would require more money than his gp pipe.

 

[cavcuz05]

im thinking about cutting mine down...just unsure how to...both ends are rivited so i think im stuck

 

[MikeN02]

im thinking about cutting mine down...just unsure how to...both ends are rivited so i think im stuck

That's how mine was, just drilled out the rivets and take the band off, then you just pull the baffle out.

Afterwards drill and rerivet or mark where the original holes are.

 

[MikeN02]

just found this link, it is a pretty good 'how to'... and look, it's MikeN02's can! haha

how-to-make-a-shorty-pipe

That was actually me, I tested it on an old R6 to see if it works.

Didn't want a can catching fire and blowing up my brand new 09 FZ6-R.

 

[stuna]

I didn't do a Dyno run which is why I went with a Juice Box. It'll be about $275 with a diagnostics and custom map.

I think I know the baseline stock HP, and they only charge $30 on saturdays with appointment for a dyno run only for numbers.

YouTube- FZ6-R With R6 Headers Setup

SOUNDS LIKE A BAD OFF IDLE LAG