Fender Eliminator Installation Guide
This is specific to the “USCGDuncan” fender eliminator. However, the basics are the same for any fender eliminator bracket.
:thumbup:Thanks 99vengeur for the installation feedback/write-up.:thumbup:
You can pre-tape or heat shrink your wiring prior to...
'04- 08 Yamaha FZ6 Fender Eliminator Kit:eBay Motors (item 250429396106 end time May-28-09 17:51:22 PDT)
will this fit the R it looks like it should be fine
It's still in rough form. I need to trim it just a bit and of course powder coat it. My signals and tag bolt lights will be in this week...so hopefully I can have it finished this weekend along with a few extra one's.
yea it's a little blurry. I used the original bolts to attach it...
Competition Werkes has finally released a fender eliminator for the FZ6R.
Check it out Competition Werkes
I think I like this one a little more than the EVOTECH offering.
I worked on and fabbed up quickly a Fender eliminator using the stock turn signals..not sure if I like it tons but I was getting flack from my Brother with that fender! LOL
we will see...need to add a light for the LP and neaten it up a bit.
May go back to the drawing board but works for...
Even though I know I lost at least 3000 hp, I had to remove the OEM rear fender. My hubby and I got to looking at it and decided that it could be fairly simple.
1.Remove the rear seat. (refer to owners manual)
2.Underneath the tool kit there are four bolts holding the fender on the bike take...