Mjs exhaust question

[Lpfm1990]

Since I'm going to be more then likely getting an fz6r here by next weekend. I want to learn what I can before hand. I'm not one to keep a bike with stock exhaust.... So been reading around. And a cheaper option I found to ditch the stock one is this one FZ6R XJ6 2009-2014 Full System Stainless Race Exhaust

Do I need the powercommander for it? Or will the bike just just fine with the stock mapping?

 

[NMdesertracer]

PCV and AIS block off plates.

 

[Lpfm1990]

Ok. But can the bike run ok without damaging anything with just the exhaust? And buy the programmer and block off plates later?

 

[Scott_Thomas]

Ok. But can the bike run ok without damaging anything with just the exhaust? And buy the programmer and block off plates later?

If you use a DB killer which will not cause the bike to lean out too much. Marthy said even the Viper and other such cans can be run on stock mapping if you use the DB killer. This will also restrict the exhaust negating some of the HP gains and the overall sound will be lower. Can be a temporary option though until you get a PC5 and AIS block offs.

 

[Lpfm1990]

Ok. Thanks. That's what I was hoping to hear. I'll get that stuff later. But for now. I'm kinda tight on money. And just found a used 2 bros full system for under $500. So that helps

 

[michaelw83]

I have full MJS exhaust. I love it. Think it was 600-650 after shipping. If u use baffle you don't need a PC or juice box

 

[michaelw83]

I have full MJS exhaust. I love it. Think it was 600-650 after shipping. If u use baffle you don't need a PC or juice box

If u don't get that I would get marthy's viper setup.not sure how much it is