I had both, the FZ1 bar and (now) the clip on's. (sorry to go against you Chucker)
Im 100% sure the clip on's are lower, however getting to this position involves lowering the bike at the front forks to avoid touching fairings etc. which isn't a requirement for FZ1 bars, hence clip ons being...
so i put some spacers in. definitely did the trick, not bottoming out, a little bit stiffer.
will hopefully swap the oil out this week or next. 40 degree (c) too hot to do anything.
should i look for 10w or 15w??
I did, however am looking at $200 + shipping just for the emulators. its an option, but I don't dislike standard that much, just after a very small amount of firmness.
Thanks for the reply guys! Yeh I meant do the oil change as well probably needs it anyway.
@shards - I had actually ordered those but the thread pitch they sent wasn't correct. Hence the thought of just putting spacers in.
Might give them a go and see what happens. I'll check in later
Hi all,
may be a stupid question here; ive tried looking it up and could find any information on doing specifically this.
lets say, I was to spin up some maybe 8mm spacers on a lathe, take the fork caps off, insert the spacer over the inner tube above the spring, and put the cap back on...
the only fairings I have trouble putting back on are the smaller black ones under the handle bars.. things have made me throw little sissy tantrums regularly.
Howdy!
I have just received in the mail a custom Matte Black and complete fairing kit from AUFairing.com.
In a turn of events, and the money needed elsewhere, I have made the difficult decision of selling the kit as a whole (read: will not separate) for the next person to fit to their...
I've had the Q3's on for a couple of months now, compared to stock Bt021's these are much better, as everyone is saying.
but a question of what pressure are you all running? every other forum says around 32 cold front 34 rear (for street) but these aren't on FZ6R's.
Any one care to share...