What are these leftover prices?

[yellolab]

Just put the bike back together, and I've got a few spare parts. Anyone know where they go?

Thx

 

[ekleptical]

Those look like the washers under the grab bar, haven't seen them anywhere else yet, and the plastic pin is from the fairings somewhere, maybe the lower front? Then again I've only owned my bike for a week...

 

[yellolab]

Those look like the washers under the grab bar, haven't seen them anywhere else yet, and the plastic pin is from the fairings somewhere, maybe the lower front? Then again I've only owned my bike for a week...

Thanks. I'll check the grab bar right now.

Where is the pin in the lower front fairing?

 

[ekleptical]

Its behind the triangular price that's screwed to the front, it connects the lower front of the two side fairings, I'm guessing it comes from there because you only have one leftover. The grab bar should have one of those washers in each of the four holes

 

[yellolab]

You were correct sir, the washers went under the grab bar. Thanks.

 

[Scott_Thomas]

That rivet could also be from the dash pieces if you had them apart. They use the same size pop rivet.

 

[AL72]

That pin looks like the ones on rear cowlings below the grab bars.

Regards!

 

[buzzbomb]

Those look like the washers under the grab bar, haven't seen them anywhere else yet, and the plastic pin is from the fairings somewhere, maybe the lower front? Then again I've only owned my bike for a week...

Darn good call! Rep to you.