Special Firmware for PCV for FZ6R

[xnethkenx]

I'm having the same stalling/cutoff issues that others seem to have after installing my PCV with a TBR map. Seems like some guys on here got a special firmware version from Dynojet which fixed it. You mind tossing it over my way?

 

[Fizzer6R]

don't think it was any different version - just that you have to keep trying to install it until it works good - here's the other thread, good luck

http://www.600cc.org/forum/f89/power-commander-5-pissing-me-off-22617/index3.html

 

[xnethkenx]

Yea i've gone through that thread a million times. Is this special firmware people are using no different than the latest ones on dynojet's website now?

I've been trying that all day with no luck.

:banghead:

 

[xnethkenx]

Ugh tried again, same nonsense. It has an awful raspy idle and chopping it over 7k makes it just die, even if i'm not moving.

Was fine before i installed the PCV, and it doesn't matter what map i use.

 

[cavcuz05]

Just updated mine and reloaded my map...NO problems...i think its actually smoother idle wise

 

[xnethkenx]

when you say updated, you mean your firmware?

 

[cavcuz05]

yes Firmware...did it twice just to make sure

 

[xnethkenx]

What else could I be missing then? I've tried the latest one off the website like 20 times....same result every time....

 

[FZ6RGUY]

PM sent to ya pal

 

[cavcuz05]

huh?...what version of the software are you using?

software 1.0.5.8?

Firmware V0.1.6.11?

 

[xnethkenx]

Yup, using both of those.

 

[cavcuz05]

all you connections good? Ground ect?

 

[xnethkenx]

Yup, gonna double check after work today though...

 

[cavcuz05]

Honestly it might be your module?...did you say it was working fine before the upgrade or has it always been doing this?

 

[xnethkenx]

Bike worked fine until I put the module in, hasn't run properly since.

 

[xnethkenx]

Finally, got the special firmware from Marthy, fixed it right up. I'm pretty sure that's not an actual firmware release, but a patch that's just applied to the existing firmware installed. Either way, thanks a ton!

 

[cavcuz05]

I need that FIRMWARE...im having the same stalling issue after i updated off there site

 

[Merc250r]

it's on marthys website I believe

Marthy Motorcycle Exhaust Solution - Tech support

 

[Merc250r]

I need that FIRMWARE...im having the same stalling issue after i updated off there site

one of the reasons I didn't want to get the PCV after hearing about issues

 

[cavcuz05]

it's on marthys website I believe

Marthy Motorcycle Exhaust Solution - Tech support

it is but i cant access it