Important Power Commander V Firmware update

[Stricken]

I just got off the phone with Jay from Dynojet. I called them because the FZ6R would stall in Neutral or if you pull the clutch in when the PC5 is installed on the bike. I tried all the settings and other maps but to no avail. He told me that this is a common problem with our bike and the PC5 and that he would email me a special firmware to fix the problem. Got the email and loaded up the firmware and NO MORE STALLS! So if you guys have a similar problem, PM me and I will forward you the the firmware Dynojet emailed me.

 

[Stricken]

I should clarify that the bike stalls when I rev the engine in neutral and when I pull in the clutch while the bike is in motion at anything above 2000 RPMs.

 

[Cmgbruschi]

I think I might have that problem. By stalling do you mean you actually have to turn the bike back on again if you rev it in neutral? Because on my bike if it's in neutral and i rev it a little over 2000 RPM's it "stalls" a little bit but not to the point where it shuts off.