rubicon1000
New Member
I installed the hid kit and the beam was all screwed up I tryed adjusting it but made it worse. Can anyone tell me which way and what screws do what on the adjustments so I can correct the light beam. Thanks
Headlight adj. After hid install
- Thread starter rubicon1000
- Start date
Here's straight from the service manual:
The screw on the lower left is for vertical adjustment. Turning that screw counter-clockwise raises the beam, turning it clockwise, lowers.
The screw in the upper right side is for horizontal adjustment. Turning that screw clockwise moves beam right, counter-clockwise moves it left.
Hope this helps. I tried to download the images, but I couldn't get them to work.
EDIT: Use a 5/16" socket. I just raised my up a bit. You can reach the adjustment without removing anything.
The screw on the lower left is for vertical adjustment. Turning that screw counter-clockwise raises the beam, turning it clockwise, lowers.
The screw in the upper right side is for horizontal adjustment. Turning that screw clockwise moves beam right, counter-clockwise moves it left.
Hope this helps. I tried to download the images, but I couldn't get them to work.
EDIT: Use a 5/16" socket. I just raised my up a bit. You can reach the adjustment without removing anything.
Last edited: