Fender eliminator with factory signals


I

ivweekends

New Member
Has anyone found an aftermarket rear fender eliminator that would accept the original turn signal lights that come with the bike? I am hoping to do a fender eliminator but keep my factory turn lights. The OEM turn signal lights don't have bolts at the end looks like they just pop in and snap in place.

If you know of a model/make please let me know. Thanks!!
 
M

MNGreg

waiting out winter
Elite Member
ivweekends said:
Has anyone found an aftermarket rear fender eliminator that would accept the original turn signal lights that come with the bike? I am hoping to do a fender eliminator but keep my factory turn lights. The OEM turn signal lights don't have bolts at the end looks like they just pop in and snap in place.

If you know of a model/make please let me know. Thanks!!
Click to expand...
On a quick note though, the one I want to get says it can use the factory ones, but it is expensive. The Rizoma FE kit. I dont know much of the others though.
 
D

deputydog

New Member
I just took the first part of the factory signal off the stem, that will leave just the signal housing and the threaded rod. Just buy some nuts that fit and add to your FE.
 

Y

yellowfz

This is the one to get; 2009 2010 2011 FZ6R FZ-6R BLACK FENDER ELIMINATOR | eBay , guy has the angle worked out so that if you hit a pothole and bottom out the suspension it survives without incident, ask me how I know.
Oh and will work with stock signals too.

I drilled a hole where the screw goes and replaced the screw with a bolt, screw will strip out easily.

The one the guy offered up for water jet is also a good one, has good angles too.
 
Last edited by a moderator:
You must log in or register to reply here.


Top