Search results

Make sure yo contact Tyler... most of the shipment is shipping today or tomorrow. I did! Thanks,

I'll go 17/47.

I went with Combo #3 - 16/46 w/Black Chain

A 7th gear would be nice!

I owned my Ninja 250 for 9 days before I bought a FZ6R. I wouldn't bother with a 250.

Did you get the switch to work?

Pretty sure that switch is for the HUB unit. You'll need to get a HUB or cut the connector off and use like a generic switch.

Is it a switch from Dynojet? Does your switch have an LED inside, you wouldnt use the 12v wire if that is the case.

The MAP connectors are the two holes closest to the center/middle of the PCV. I use a switch to go between Marty's AdvGear MAP and his Touring MAP - very handy!

That looks nice!

Marthy's Trunk Rack I bought one of Marthy's Trunk Racks and love it! The trunk I got from JC Whittney for like 75 bucks. Dr. X

Donny at Dynoworks - Home in Sarasota, FL is where I will go if I end up going that route. He is an authorized Dynojet PC Tuner. Bill

Thanks! Thanks for the advice. I think I will install the ones listed on ebay (Thanks NastyButler) and try out Marthy's Maps before I have it dyno tuned. Dynoworks is just a few miles from my place, but its $300 for the tune. Looking forward to the new sound though! - Oh and a shout out...

Hello All, I just bought a TB Black Series CF exhaust W/PCV and had a couple questions for those of you that have this setup. 1. Do I "need" block off plates? 2. Are there maps available for our bikes or will I need a custom tune on a Dyno? Thanks, Bill

Bradenton/Sarasota I'm in Lakewood Ranch near Bradenton.