Thank you, so far i've tried scratch remover for cars and car wax, no success yet. I'll let you know how the watch scratch remover turns out when it comes in the mail. Also note to self, putting the bike on the rear stand before would help level it out.
I'm glad your not paying attention to what everyone else is doing. In my area ( columbia, MD. Most of the people i see are just with a helmet, but still i gear up everyday. The one day i didn't i was moving and had my gear in the moving truck. I was went to my new place when it was dark and had...
I've actually been looking into this myself and i saw a few different options. One is lowering the front end to place wood craft clip on 1.5 inch risers that would allow clearance. Danmoto also makes adjustable riser clip ons that will fit the bike and is a little bit cheaper. I saw another post...
I just got done upgrading to some stainless steel brake lines, but in doing so, i kind of made a mess. The fluid reservoir spilled a bit when i removed the cap. It was my first time doing it, so i was a little less cautious then i should've been when removing it. Point is i got brake fluid all...
Someone asked for a how to for this awhile ago and finally got around to it. I installed these DRL's that i found on ebay.
2X 30cm Flexible Car Soft Tube Guide LED Strip Lamp DRL Daytime Running Light
When i installed these i had everything torn apart already, so i did have easier...
I went through the same thing with mine. I ordered some aftermarket mirrors and i couldn't see nothing, but myself. I didn't feel like sending them back. Black LED Intergrated Turn Signals Mirrors for Kawasaki Ninja 250 636 zx6r ZX10R | eBay
Sooo i ordered zx6r mirrors, but they wouldn't fit...
For me i switch between two positions. Chest resting on the tank trying to put most of my weight there to put less pressure on my back or completely upright with arms extended all the way. Depending on what i'm doing and how long i've been riding. When i have my chest against the tank, i try to...
For me i experienced an issue with my front brakes locking up. I switched out my levers, so when i went to ask if my warranty would cover it. They said since i swapped out my levers, they would not. Apparently it voids the warranty. I am guessing if you change something to an aftermarket part...
nice info! I did end up getting the bike started. I took the battery out and tried charging it that way and it worked, but it got up past 14 while on the charger. So that means its sulfated even though the bike started after i put it back on?
I didn't notice any corrosion when i pulled up the seat to check the voltage to see if it was charged enough. Also i was using the plug for easier access to the battery without having to pull up the seat. It came with the bike, but i do know it worked before the bike wouldnt start.
I had a big snow storm recently and the bike was outside covered, but by the end of the snow storm, it was almost completely covered. I tried starting it today, it's probably been 3 weeks since i last started it. I charged it and it said the battery was full after a few hours. I tried starting...
I got them on my bike and they are great, got in an accident awhile ago and they got scuffed up but protected my bike some. yeah i had a similar setup before, i was doing some work on the bike and needed it lifted. but it kept sliding, because the swingarm is slanted. I think it was a good...