Vader Led turn signals (Non Flush type).

[AL72]

Well,I had installed the MotoDynamics flush led turn signals, but I think they have a poor front visibility. So I bought a "Vader" style led turn signals, an adapter plates set, a resistor set, and a wire plug adapter set (for no cut the bike installation).I installed everything and it looks great.
Note: the turn signal stalk is wider than the plates hole, don't drill the plates because are very fragile (I broke one inner plate), so you must warm the bit in the stove and let the heat make the work.

And about the leftover flush turn signals... I put it in the rear fender for more rear visibility (without the resistors).

Regards!

 

[saberX]

hey,

r these the plates that you had bought?
"Not Plastic" These Are Aluminum Yamaha FZ6R FZ 6R Turn Signal Adapter Plate | eBay

Can you also plz link to the wire plug adapter?

I really like these vader style t/s

 

[AL72]

Nop, I ordered these: Stalk Turn Signal Adapter Plate Yamaha TMAX YZF R1 R6 R6S FZ FZS FZR 1 6 8 09 10 | eBay

These are the wiring adapters, I bough with this seller: Yamaha Turn Signals Wire Plug Adapters YZF R6 R6S R1 FZ6 FZ1 FZ 6R 09 10 TMAX | eBay

Regards!

 

[saberX]

thnx

is it possible for u to tell what the stalk/stem size for those t/s is? was it 10mm?

 

[AL72]

Yep, 10mm.

Here the link where I bought them: Black Stalk LED Turn Signal Suzuki GSXR Honda CBR Kawasaki Ninja ZX Yamaha R1 R6 | eBay

Regards!

 

[saberX]

I found these which have 19 leds but a bit longer.
"Vader" Ultra LED Turn Signal Light Indicator Blinker Yamaha YZF R1 R6 08 09 10 | eBay

r urs plenty bright even in daytime with only 16 leds?
From the photos it looks like urs r fine too.

 

[AL72]

O yeah, have excellent visibility in daylight with 16 leds.

Regards!