6R Blackout
New Member
I have a set of T-Rex stands both front and rear, I have the spools for the rear and my rear stand works WONDERFUL! I also have the front triple tree stand, but for some reason it is not working properly, when I insert the pin and raise the front end it goes up and holds the bike up as it should but I noticed it was not holding the bike all the way by the pin under the triple by itself it was in the whole but the bike was also resting on the bottom part of the light!
Is this correct?
Is the pin the wrong size allowing it to slip out of the whole a bit?
Does anyone else have this problem or had this problem with there front triple stand?
Please I need some answers and help!
Many thanks to all in advance!
Sent from my iPhone using Tapatalk 6R Blacout
Is this correct?
Is the pin the wrong size allowing it to slip out of the whole a bit?
Does anyone else have this problem or had this problem with there front triple stand?
Please I need some answers and help!
Many thanks to all in advance!
Sent from my iPhone using Tapatalk 6R Blacout