Recent content by SEALBoy

I felt that my clutch on my 09 FZ6R required too much force to be used comfortably. I re-lubed the clutch cable today, and while the action is smoother, the force required to hold the clutch in position hasn't changed. Does anyone know how to decrease the forced required? All I can think of is...

Let's say I have enough faith in my mechanical abilities to do it the normal way... what lube should I use?

My clutch handle requires a lot of force to squeeze. I have a couple questions: 1. Is there any way I can adjust the force required to pull the clutch in without lubing the clutch cable? 2. If I have to lube the cable, what is the procedure for this? Do I have to remove the cable entirely...

Doesn't it look like your turn signals were blinking way too fast? I installed this in sequential turn mode and the resistor pack I had was bad for the left turn signal - it would blink way too fast and not light up sequentially. When I got my replacement resistor pack it worked perfectly.

Thanks, I'll stop by Lowe's tomorrow and pick up a set of hex drivers to use with my socket wrench... see if that works.

I'm trying to remove the four bolts under the toolkit so I can install my fender eliminator. I'm using the hex wrench from the tool kit which looks to be a perfect fit - however, I can't get a single bolt to loosen. Did anyone else run into this problem? I'm scared that I'll break the bolt head...

Picked it up yesterday, a white 2009 with 1520 miles. Haven't had a chance to really ride it due to rain, but I'm hoping to take it out later this week. Got the decals off the main fairings, and ordered some black vinyl to cover up the tank decals. Very excited, I'm moving up from my first...