Recent content by dailordasailor

I replaced my "main" relay that works with the kickstand, clutch, starting, etc. $50 but when i tested the old one it had an open circuit it shouldnt have had. The problem being i cut the main harness with my seat and now the bike will shut off the second i kick it into gear. I replaced the...

In the middle of selling a house 12 hours away so this has taken a back burner unfortunately. I took off the switch, checked it, etc. Checked ohms. Everything works how it should. I'm headed to garage shortly to see if I can jump bike the way I did when it firs died on me. Disconnect clutch...

jumped the wires with no luck. traced it up under tank and tried jumping it at that connector with no luck. What else should i look at? Must have a fuse or a relay in line?

so a jumper wire on the kickstand and on the clutch would be as if the stand is up or down? I want to jump both to make it run?

Thought with a new problem, I should start a new/cleaned up thread. If mods could delete old one id appreciate it. Long story short, my bike lost all electric all of a sudden when driving and shut off. After checking bike over I found a couple blown fuses and the fact that my seat had rubbed...

sorry for the very late reply. My boss at work was injured monday so my work load has become rather large and heavy. Today i finally got my new neutral switch (well kinda, i borrowed it off my buddies 07 R6. mine will be in tuesday). Neutral light works great, bike starts right up. Current...

thank you very much for the video man! mine is plugged in and I actually removed the switch. No idea how to "fake" the signal for it. That being said, when you disconnected it you could pull the clutch and kickstand and start the bike. I cant do that... I still have to jump the starter...

Cant thank you enough for the help! Hopefully its the exact problem and wont be too expensive to replace :)

98- thank you very much. I'll try to figure out how to make the clutch plug read like its good. When comes to the kickstand i dont know how i would false that? I dont see a plug but more of wire going directly into the sensor and one bolt holding that in? Make sense?

Thank you very much! I feel that there must be something directly linked to the neutral switch and thats start of all the problems... Im bypassing the clutch safety switch (by unplugging it) as well as kickstand safety switch (by kicking it up) and then can jump starter solenoid... but...

Please see other posts. Mods please delete this one. Thanks so much for the help guys!