acomeaux33cx
New Member
Just installed new tires. Have a little wobble. What could cause this?
Head wobble
- Thread starter acomeaux33cx
- Start date
Theres alot to look at when ur trying to make something spin that fast smoothly lol
*May need to be balanced
*bead might not be set on one part
*rear axle may need to be aligned
acomeaux33cx
New Member
CycleGear installed the tires on the rims. So they should be ballanced.
check the bead i had my wheeler tires beaded by a shop and they didnt bead one side!!!!
300 jumps later it poped into place hahaacomeaux33cx
New Member
Whats bead lol
Same happen o me when I installed my new PR2. It scare the crap out of me the first time it happen. As they wear out it will be fine. That's the main reason why I went back to the Conti Motions. The tire is not as rounded and more like a touring tire but with dual compound.
What brand of tire did you installed?
Note: Lower your pressure a bit, that will enlarge the contact patch and help a bit.
What brand of tire did you installed?
Note: Lower your pressure a bit, that will enlarge the contact patch and help a bit.
acomeaux33cx
New Member
I installed the conti motions.
the bead is where the tire is acutely locked into the rim
Tire bead - Wikipedia, the free encyclopedia
it basically holds your tire in prefect place if its not beaded it can roll off the rim!!!
Here this image kind of shows you how there is a notch that the tire sits in
If you keep it clean and ride the calmer roads it's fine. But the mess that wet roads create on the bike is just horrible and a royal pain in the butt to clean up.